MicroNet BroadLink SP3353 Guide d'installation télécharger pdf (Page 32)

PPPoA routed: Point-to-Point Protocol over ATM bridged mode

IPoA routed: IP over ATM Routed mode

PPPoE routed: Point-to-Point over Ethernet routed mode

PPTP: Point-to-Point Tunneling Protocol

Edit PPPoE –

After clicking the “Edit” entry, you could modify PPPoE parameters.

Edit “ATM channel” –

The “ATM channel” is very important parameter, please reference to

your ISP’s technical documents.

Tx Vci/Vpi – Virtual Circuit / Path Identity of ATM transmission rate

Rx Vci/Vpi Virtual Circuit / Path Identity of ATM receiving rate

Edit IP Interface –

The WAN IP interface values

Edit “RIP Version –

RIP protocol values for routing table exchange

Edit TCP MSS Clamp –

MSS Clamping values

5.5. IP Routes:

You can create a Static Routing table manually to administrate the network traffic

when dynamic routing is not effective enough. To start the configuration, click the

“Static Route” and fill in the following data.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 65 66

Pas de commentaire

MicroNet BroadLink SP3353 Guide d'installation Page 32