MicroNet Fibre to SAS/SATA II RAID Subsystem Manuel d'utilisateur télécharger pdf (Page 151)

FIBRE-to-SAS/SATA RAID SUBSYSTEM

User Manual

151

For SES2 board PRO-90-5601:

a. To upgrade proSES firmware, connect RS232 cable (Phone-Jack to DB9) from

RS232 port of SES module to available serial port of your PC.

b. Open “HyperTerminal” in your Windows PC and setup as follows:

Settings

Baud Rate 115200 (for SES board PRO-90-5601)

Data Bits 8

Parity None

Stop Bits 1

Flow Control None

c. To access the SES console, press <ENTER> at least once to verify the SES

console session has been established (a “-->” prompt should appear if

configured properly).

d. At the prompt, type “proses upgrade”, followed by <ENTER>.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 159 160

Pas de commentaire

MicroNet Fibre to SAS/SATA II RAID Subsystem Manuel d'utilisateur Page 151