MicroNet Fibre to SAS/SATA II RAID Subsystem Manuel d'utilisateur télécharger pdf (Page 22)

FIBRE-to-SAS/SATA RAID SUBSYSTEM

User Manual

4. Hard Contact Relay

5. System Light

a. The System Light is used to indicate whether the SES Module is on and

whether or not there is an error.

b. A blinking GREEN light indicates that the SES Module is ON and

functioning normally.

c. A steady GREEN light or no GREEN light indicates that there is an

error with the SES Module.

2.3.3 SES Module LED

2.3.4 SES Module Installation

This section describes how to install the SES Module.

a. Check for damage, especially to the PCB Golden Fingers at the rear of the SES

Module.

CAUTION! Handle the module with care and avoid damaging the

Golden Fingers. In addition, make sure there are no fingerprints on

the Golden Fingers. Do not install the module if the Golden Fingers

are damaged.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 159 160

Pas de commentaire

MicroNet Fibre to SAS/SATA II RAID Subsystem Manuel d'utilisateur Page 22